Are you sure you know how to change a car wheel properly?
Watch our new video for simple and clear instructions from Maksym at Hunters Garage. Even a petite blonde handled it perfectly without help ;) In short: Grab the wrench (cross or T-shaped) and loosen all four bolts on the flat tire. They’re tightly screwed, so to “break” the bolt, stand on the opposite end of the wrench and press down. Place rocks behind the rear wheels to keep the car from rolling. Take the jack. Feel for the reinforced spot under the side doors (closer to the wheel). Place the jack there. Once it’s positioned, start lifting the car. When the flat tire is off the ground, you can proceed. Remove the loosened bolts with the wrench. Carefully take off the damaged wheel and replace it with the spare. Make sure there are exactly 4 studs. Tighten the bolts by hand first, then use the wrench to secure them. Lower the jack and check that the bolts are tight enough to prevent the wheel from falling off while driving. Use a tire pressure gauge to check pressure. Open the valve cap and press the gauge onto the valve. Optimal pressure is 1.8–1.9. Don’t forget to collect your tools—and you’re good to go.
